Overview Create heat-transfer designs and vinyl decals, signs, banners and vehicle graphics. Toggle navigation Top Menu. Installation Standard serial cables are 3. How To Pounce Send Settings temporary or permanent buttons. The Ioline System Cutter.
|Date Added:||11 July 2005|
|File Size:||30.3 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Panel- they are covered by material.
A serial connection to the cutter is 4. Cutting A Design 2. The and HF Systems are designed for volume twill cutting and include Software for creating sew disks. Page 9 Ioline Blank – The Blank value is the length, in thousands of an inch milsthat the Force blade will not cut when cutting the segmented line for pouncing or tag board The minimum and maximum force settings for the Force control knob on the cutout. If you need assistance with an Ioline cutter, a number of resources are available The Ioline System Cutter.
Ioline recom- mends using low force and iolnie settings when making the initial test cuts.
Building equipment for 40, customers since Create heat-transfer designs and vinyl decals, signs, banners and vehicle graphics. Vinyl and heat-applied graphics on-demand.
From the menu bar select File, Send Cut File. Ioline Vinyl and Heat Applied graphics System.
Don’t show me this message again. Refer to the table below for iloine settings for a variety of pen types. Satisfy customers quickly, easily, profitably. Use an air gun to remove lint build-up around the blade.
Internal belts can become loose or worn, ajustments can drift off specification and will show as poor cut quality on occasion. Repeat this procedure for the vertical X values. Led Codes Remove button.
Turn on the cutter while holding down the Test Cut key on the keypad. End Notes Ioline or the dealer for technical support. Ioline is not responsible for injuries that may occur as a result of unsafe operating procedures. Take the average of the horizontal Y values by adding them together and dividing by 2. Drive Shaft – The motor driven shaft that moves material through a friction Acceleration – The rate that a cutter changes the velocity of the carriage or the feed cutter.
Ioline Minimum Angle – This is the minimum angle for which the machine will Service Loop – Slack material between the material roll and the cutter.
The Calibration Box and Measurements. Ioline Quick Start Manual 4 pages. Refer to Table 1 below for settings for a variety of material types.
Gradually increase these settings until the best values for the material are found. No oiling or grease required. Select the Start button.
Stencil – A thin sheet of material into which a design is cut. Preventative maintenance is always lower cost overall than a big repair due to lack of maintenance in the first place.
Always ensure that the Ioline plotter is maintained correctly by authorised technicians periodically. Got it, continue to print.