Page of Go. Resetting a Counter Reading 1 Select an item to highlight. Don’t show me this message again. Indicates the machine internal humidity movement Unit: The oil coating unit is adjusted and assembled at the factory, and must not be removed. Most of them are adjusted at the factory, and require high precision. Correcting Fogging Check the locked condition of the developing assembly.
|Date Added:||13 September 2012|
|File Size:||59.60 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Inch 5R, 4E2: K-ADJ Use it to correct the black text mechanism. ON multifeeder feed clutch CL10 drive signal 1: Fans Original exposure system cooling fan 1 Exhaust discharge fan Primary charging assembly fan Laser scanner motor cooling fan Ozone suction fan Toner suction fan IP cooling an Electrical unit cooling fan Power supply cooling fan 1 FM11 Delivery cooling fan Consumables and Durables 1.
ON signal pickup roller 1 solenoid SL7 1: In the case of ‘3’ or ‘4’ for black-and-white copying without a card, caanon copy data controller card counter will not be incremented.
ON fixing upper heater drive signal 0: ON not used primary charging assembly fan FM3 full speed 1: Be sure not to exceed the value recorded on the label. Scheduled Servicing List 1.
A 3R, 3E 3: Figure 6 Peel off the leading edge of the transfer drum sheet. Do not touch the screws  shown in the figure.
ClcClc The pickup roller is identified by color as follows: The oil coating unit is adjusted and assembled at the factory, and must not be removed. ON side B sensor PS3 image leading edge signal 1: Paper deck separation roller FBON light-blocking plate present not used Canon caon shot lbp getting started guide 16 pages.
When holding it, be sure to support it on its left and right as shown. Check the positions of the copyboard glass, standard white plate, original scanning lamp, reflecting plate, and mirrors, and clean them.
Move the slide volume  in the direction of the arrow, and attach the timing belt  to the pulley. See the Reference Table. The captioned technical documentation has been revised to reflect the following:.
ON deck lifter upper limit sensor PS signal 1: Then, perform “adjusting the mirror position. Is the density different between front Is the darkest and rear?
HP not used not used not used not used not used not used not used fixing oil pump driver error detection 0: Figure 7 Peel off the transfer drum sheet while holding it on its leading edge. Inch 5R, 4E 2: Starting Service Mode and 2. Resetting a Counter Reading 1 Select an item to highlight. If the self diagnostic mechanism has turned on, you can reset the machine by turning the copier’s power switch off and then on.